Ember the Chonk Dragon

• All our models are printed with multiple walls and increased infill using high-quality, non-toxic PLA for maximum strength and safety.
• Each Wiggly Stuff figurine is 3D-printed and hand-finished, so slight imperfections, visible layer lines, colour shifts in the filament, and tiny variations are normal -and make every piece uniquely yours.
• Gradient and rainbow colour patterns occur randomly and may vary from batch to batch.
• Actual filament colours may vary slightly from what you see on screen due to dye-lot differences and monitor settings.
• Each figurine is carefully packaged with protective packaging to ensure it arrives in perfect condition.
• Please inspect your figurine upon arrival. If you have any concerns, contact us before leaving feedback.

Your Wiggly Stuff figures are built to last - with a little TLC!

• Keep cool: PLA softens above ~60 °C (≈ 140 °F). Avoid leaving your figurine in direct sun, inside hot cars, or near heaters.
• Gentle cleaning only: Rinse under lukewarm, soapy water. Use a soft brush or toothpick to clear any dust or debris from tight spots.
• No dishwashers or ovens: High heat or harsh detergents can warp or weaken the plastic.
• Handle with care: These figures are flexible but not indestructible. Don’t bend or twist parts beyond their normal range, and avoid strong lateral pressure.
• Display tip: For best colour retention, keep your figure out of prolonged UV exposure - indoors on a shelf or in a display case is ideal.

• We do our absolute best to ensure our prints are free from sharp edges, but minor imperfections may occur - please inspect each piece before play.
• ⚠️ Choking Hazard: Wiggly Stuff figurines contain small parts and are not suitable for children under 3 years. Always supervise young children during play and use your discretion when gifting these items.